Yesterday, reporter learned from Shanghai Academy of Spaceflight Technology, the hospital in Temple One goal of the task assumed aircraft cabin structure and assembly of resources, power sub-systems, docking mechanism subsystem, control and communication subsystems supporting stand-alone subsystems and overall circuit Resource module cable network research task.
Resource tank “fuel” an increase in total weight was reduced by 10%
Temple One of the energy as a source of resources and power module, and the JEM to be connected with the launch vehicle, in addition to ensuring a reliable connection, the cabin is also equipped with a number of subsystems within and outside the nearly 200 sets of equipment and a large pipe, cable and so on. The structure of the resource module design, installation and testing have brought a lot of problems. Development process with a large number of new technologies, new processes.
Designed from the start, the resource module is facing, “weight” problem. Because the resources to carry propellant tank before the Shenzhou spacecraft than an increase of 50% or more, but the construction of the main cabin still hope for the implementation of weight loss. In this way, before the use of aluminum is difficult to meet the requirements, the first use of aluminum-lithium alloy as the raw material, 10% of successful weight loss for the cabin.
In order to maintain long-term in-orbit requirements of the target aircraft, the entire device carried by the lofty air and oxygen-carrying capacity of a single spacecraft, for environmental control and life support sub-system uses a large-capacity high-pressure composite cylinder for gas storage. It is reported that the inflatable cylinders before and after the change in the direction of larger diameter, the resource module assembly with a certain flexibility in design of cylinders installed bands, difficult to install to solve the problem of the cylinder, greatly reducing the weight of the cylinder mounting bracket for the entire device contributed to weight loss. Aluminum Casting Heat sink parts
Power solar “wings” using new technology
For manned space flight, the aircraft power subsystem has always been the lifeline.
This time, Temple One pressure on the semi-rigid solar wing, the technology of China’s first spacecraft power subsystem applications. Externally, two solar wings like a pair of “wings” covered with horizontal black solar film, artful. The face of low-orbit space station environment, before the full use of high-orbiting satellites are obviously not applicable to rigid panels. After a number of technology experiments, researchers identified the Shanghai grid panels with fiberglass glue and glue concentration in the actual operation and other parameters to determine the carbon-fiber frame with glass fiber mesh of semi-rigid structure.
Butt has gone through 16 years of R & D away
For eight and Temple of God “space Kiss”, Shanghai Academy of Spaceflight Technology 805 development team started from 1995, Principles of docking technology, simulation to explore, to create in 1999 a first prototype of 1:1, from 2000, ten key technology component-level research, developed in 2002 for engineering applications of docking mechanism and the four large-scale research prototype system-level ground simulation test equipment, docking mechanism 2005, sub-systems from the official project to be completed in December 2009 initial research into the positive kind of work, completed in November 2010 is kind of product development to deliver, to the range of 2011 to the base test, the 16-year road to product development from scratch, Aluminum Casting Anodized from there to fine, docking points The journey continues … the system …